contact us

Land Rover LR4 Air Suspension Programming

Land Rover LR4 Air Suspension Programming

Land Rover LR4 Air Suspension Programming

In the video how to program the suspension control module on land Rover LR4 models is shown using Autologic's DrivePRO.

Begin by identifying the vehicle you’re working on

Select Land Rover

Select Automatic Detection

Select Ok

Select Module Programming and Replacement

Enter VIN for the vehicle you are working on

Select Ok

Read and understand the warning

Be sure your vehicle power supply is correctly connected

Select Yes to continue, Select No if corrections are required

Land Rover module programming guide available on Autologic website. Select Ok

Locate the module you wish to program. In this example we are programming the Ride Level Control Module (RLM)

Select Next

Select Ride Level Control Module (RLM)

For new control modules select YES, for updating existing modules, select NO

In this example we are updating an existing control module. Select No

Enter VIN

Select Ok

The vehicle order is saved. Send orders to Autologic using the Download Manager

Select Ok

Select DrivePro

Select Module Programming & Order Manager

Select Send Orders

Select the order for the vehicle you’re working on

Confirm the information is correct, and select Send

Select Ok

You will receive an email when your programming file is ready

Select Module Programming & Order Manager

Select Download Orders

Select Install next to the order for the module you’re programming

When the download has successfully applied, Select Ok

Select the Back arrow

Select Back arrow again to return to the DrivePRO home screen

Navigate to Module Programming and Replacement

Select Ride Level Control (RLM)

Select No

Enter VIN

Select Ok

Read and understand the warning

The DrivePRO device will now be put into a diagnostics only mode. All other applications will be closed and the Menu and Diagnostic buttons will be disabled

Select Ok

To begin programming, select Program

When programming is complete, you will receive a message stating the programming has been completed successfully

Select Ok