contact us

How to Program Control Modules (units) on Porsche 996 vehicles

Programming Porsche Control Modules using Autologic DrivePRO

In this article and video a Porsche 996 DME will be programmed, other vehicles and control modules will follow a similar procedure

 

Be sure the vehicle being programmed is connected to a vehicle power supply designed for programming Porsche vehicles

You will need immobilizer codes for the vehicle you are going to program

Begin by identifying the vehicle you are working on

Select DRIVE

Select DME

Select immobilizer code programming

Select EDIT existing DME programming code for this module

Enter the DME programming code

Select OK

Select EDIT existing immobiliser code for this module

Enter the immobiliser code

Select OK

Select EDIT new DME programming code for this module

Enter the DME programming code

Select OK

Select EDIT new immobiliser code for this module

Enter the immobiliser code

Select OK

Select PROGRAM

Read and understand the message. Confirm the all entered codes are correct

Select CONTINUE

Select OK

Select BACK

Select existing module programming

Confirm the date is correct, edit if necessary, if correct select continue

Select the arrow to continue

Locate the DME system the vehicle you are working is equipped with

Select PROGRAM

Read and understand the warning. Select CONTINUE

Programming will begin. Please wait while all blocks are programmed

Select OK

Select OK

Check for stored fault codes, clear if necessary